Ricoh Aficio IS 2425 Operating & Troubleshooting Instructions page 27

Problem
Parts of images are not
copied.
Images appear only par-
tially.
Black lines appear.
White lines appear.
White lines appear.
Copies are blank.
A moiré pattern is pro-
duced on copies.
Black spots appear on the
copy of a photographic
print.
Reference
"Copy Paper", About This Machine
"Placing Originals", Copy/Document Server Reference
"Adjusting Copy Image Density", Copy/Document Server Reference
"Selecting the Original Type Setting", Copy/Document Server Reference
Cause
The correct paper size is
not selected.
The paper is damp.
The exposure glass or
scanning glass is dirty.
The exposure glass or
scanning glass is dirty.
When D is blinking, ton-
er is beginning to run
out.
The original is not set
correctly.
Your original has a dot
pattern image or many
lines.
Because of high humidi-
ty, the photographic
print has stuck to the ex-
posure glass.
When You Cannot Make Clear Copies
Solution
Select the proper paper size.
Use paper that has been stored in the
recommended temperature and humid-
ity condition. See "Copy Paper", About
This Machine.
Clean them. See p.101 "Maintaining
Your Machine".
Clean them. See p.101 "Maintaining
Your Machine".
Add toner. See p.81 "Adding Toner".
When using the exposure glass, face the
originals down. When using the ADF,
face them up.
Place the original on the exposure glass
at a slight angle.
Place the print on the exposure glass in
either of the following ways:
• Place an OHP transparency on the ex-
posure glass, and then place the print
on top of the OHP transparency.
• Place the print on the exposure glass,
and then place two or three sheets of
white paper on top of it. Leave the ex-
posure glass cover or auto-document
feeder (ADF) open when copying.
2
19