Life Fitness CLUB SERIES Assembly Instructions Manual page 8

FIGURE 5
STEP 5:
• Slide one 2" ACCORDION SLEEVE (30), one 3" ACCORDIAN SLEEVE (31) and two PILLOW BLOCKS (23) over the shaft of the
PIVOT ARM (4) as shown in FIGURE 5.
• Assemble four 3/8 X 3" BUTTON HEAD CAP SCREWS (18) and four STARLOCK WASHERS (20) to the the PILLOW
BLOCKS (23) as shown in FIGURE 5
40
19
21
22
TIGHTEN!
SET SCREWS
23
3/8 X 3" 18
BUTTON HEAD
FIGURE 6
STEP 6
:
• SECURELY assemble the PILLOW BLOCKS (23) on the PIVOT ARM (4) to the PIVOT ARM SUPPORT (2) using the four
previously inserted 3/8 X 3" BUTTON HEAD CAP SCREWS (18), four 3/8" SAE WASHERS (21), four RH WASHERS (22),
four 3/8" LOW HEIGHT LOCK NUTS (19) and four RH CAPS (40) as shown in FIGURE 6.
• IMPORTANT! When PIVOT ARM (4) is centered and level in the PILLOW BLOCKS (23), tighten the PILLOW BLOCK set
screws.
SEE PAGE 17 FOR WORK ARM AND TIBIA PARTS
30
4
4
18 3/8 X 3"
BUTTON HEAD
20
31
23
2
8