Cisco ASR 903 Installation Manual page 47

Overview
Ports on the OC-192 are numbered from 1 to 8.
• Ports 0 to 7 are multi-rate ports, that support OC-3, OC-12, OC-48, Fast Ethernet interfaces, and the 1
• Port 8 is the 10 Gigabit Ethernet port that supports the OC-192 interfaces.
Port Restrictions
• The SFP+ port configuration is supported only on OC-192 interfaces port. If this port is enabled, other
• Each SFP port can be configured for SONET or Ethernet.
• SFP ports configuration parameter, (see the table given in Port Combinations Usage Guidelines section):
Note 1 Gigabit Ethernet port configuration is not supported.
• Seamless migration from SONET to 1 Gigabit Ethernet interfaces is supported on all SFP ports
Port Combinations Usage Guidelines
SFP+
Port
SPF
Port
For information on supported SFP modules, see
Sheet.
For more information about installing an optical interface module, see
Gigabit Ethernet interfaces.
SFP ports cannot be used (see the table given in Port Combinations Usage Guidelines section).
• Maximum of 4 x OC-48 interfaces are supported per interface module
• For each OC-48 port enabled, neighboring SFP ports cannot be configured
• OC-3 and OC-12 port configuration is supported on all ports simultaneously
• 1 Gigabit Ethernet port configuration is supported on all ports simultaneously
Or SFP+
SFP+ OC-192
Port
Port
8
7 — SPF
Port
6 —
5 —
4 —
3 —
2 —
1 —
0 —
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
Or SFP+
SFP+ —
Port
Port
8
7 OC-48 SPF
Port
6 —
5 OC-48
4 —
3 OC-48
2 —
1 OC-48
0 —
Cisco ASR 900 Series Aggregation Services Routers Data
Port Restrictions
Or SFP+
SFP+ —
Port
Port
8
7 OC-3 SPF
Port
6 OC-12
5 OC-12
4 OC-3
3 OC-3
2 OC-12
1 OC-12
0 OC-3
Interface Module Installation.
SFP+ —
Port
8
7 1 GE
6 1 GE
5 1 GE
4 1 GE
3 1 GE
2 1 GE
1 1 GE
0 1 GE
37