ResMed Positive AirwAy Pressure Device S8 Series II User Manual page 15

Problem/Possible Cause
Excessive leak.
Displays error message:
xxxx defines an error)
Component failure.
Displays error message:
Air tubing is loose or blocked.
The following message is displayed on the LCD after you try to update settings
or copy data to the Data Card:
Data Card is not inserted correctly.
The Data Card is only partly
inserted.
You may have removed the Data
Card before settings were copied to
the S8 II.
The card is not a ResScan Data
Card.
The following message is displayed on the LCD after you try to update settings
or copy data to the Data Card:
There is a data error on the Data
Card.
The following message is NOT displayed on the LCD after you try to update the
settings using the Data Card: Settings Success Remove Card
The settings were not updated.
Solution
Adjust position of mask and headgear.
Replace caps if missing from ports on mask.
Air tubing may not be connected properly. Connect
firmly at both ends.
Air tubing may be kinked or punctured. Straighten or
replace.
SYSTEM ERRxxxx Call Service!
Record error number and call service.
Check tube!! Key if done
Check that the air tubing is connected securely to your
mask and the air outlet to the front of the S8 Series II.
When you have checked the air tubing, press the Start/
Stop key to restart the device. If this does not clear the
message, disconnect the power cord and then
reconnect it to restart the device.
Card Error Remove Card
Check that the Data Card is inserted into the Data Card
module with the arrow facing up, while the S8 Series II
is switched on and not delivering therapy (standby
mode).
Ensure that the Data Card is inserted into the Data Card
slot as far as it will go.
Reinsert the Data Card and wait for the Settings
Success Remove Card message to appear on the
LCD.
Only use a ResScan Data Card.
Settings Error Remove Card
Contact your clinician immediately.
Contact your clinician immediately.
or Exxxx (where
Troubleshooting 13