Daily Cleaning Of The Mask; Technical Specifications; Pressure/Flow Curve; Flow Generator Setting - ResMed CPAP User Manual

D C
AILY LEANING OF THE
Disconnect the main air tubing from the swivel.
The R
M H
ES ED OSPITAL
cleaned using a 70% v/v isopropyl alcohol swab or by wiping with a damp, soapy cloth. If
using a damp cloth, use mild soap or diluted dishwashing detergent. Allow to air dry out of
direct sunlight.
Note: Do not disassemble the mask.
CAUTIONS
Do not use solutions containing bleach, chlorine, aromatics, moisturizers,
•
antibacterial agents, or scented oils to clean any part of the system or air tubing.
These solutions may cause damage and reduce the life of the product.
Do not expose any part of the system or tubing to direct sunlight as it may
•
deteriorate.
If any visible deterioration of a component is apparent (cracking, crazing, tears, etc),
•
replace the mask.
Check the vent holes for blockage. Ensure the vent holes are cleaned regularly.
•
T S
ECHNICAL PECIFICATIONS
P / F
RESSURE LOW
Note: As a result of manufacturing variations, the vent flow may vary from the values listed in
the following table.
Pressure Flow
(cm H O) (L/min)
2
4 19
8 28
12 34
16 40
20 45
F G
LOW ENERATOR
Select "Standard" as the mask option, when using the R
with ResMed flow generators that have mask setting options.
D S I
EAD PACE NFORMATION
Explanation: Dead space is the empty volume of the mask up to the swivel.
The dead space of the mask varies according to cushion sizes, but is less than 104 mL.
E
NVIRONMENTAL
Operating Temperature: 41°F (5°C) to 104°F (40°C)
Operating Humidity: 15–95% relative humidity
M
ASK
is for single patient, multi-use. The mask may be
N M
ASAL ASK
C
URVE
50.0
45.0
40.0
35.0
30.0
25.0
20.0
15.0
10.0
5.0
0.0
4 6 8 10
Pressure (cm H
S
ETTING
C
ONDITIONS
(
OR AS REQUIRED
12 14 16 18 20
0)
2
M
ES ED
)
H N M
OSPITAL ASAL ASK