Cleaning The Mask In The Home; Between Atients - ResMed MIRAGE NV 2 Series Clinicians Manual

C M
LEANING THE ASK IN THE
Note: Wash the headgear before first time use, as the
dye may run. It is important to always handwash the
headgear.
1 Detach the mask from the ventilator and separate
the headgear, luer lock port caps, cushion clip,
mask cushion, and forehead pad clip assembly (if
attached).
2 Handwash the headgear in warm, soapy water. Use
a mild detergent such as pure soap. Rinse well and
allow it to air dry out of direct sunlight. Do this at
least once per week.
3 Handwash the mask components in warm, soapy
water. Use a mild detergent such as pure soap.
Rinse the components well and allow them to air
dry out of direct sunlight. Do this after each use.
P
RECAUTION
• Do not use bleach-, chlorine-, alcohol-, or aromatic-
based solutions, moisturizing or antibacterial soaps,
or scented oils to clean any part of the mask
system, including headgear. These solutions may
cause damage and reduce the life of the product.
•
H
OME
C
THE
The following are the recommended and validated
procedures for cleaning, disinfection, and sterilization of
the M
each healthcare facility consult its own procedures
before carrying out the following instructions.
WARNING :
that deviations from the procedures listed below, and
their effect on the performance of the product, will
be acceptable.
1
2
Do not expose any part of the mask system or
tubing to direct sunlight as it may cause the
product to deteriorate.
D
LEANING AND ISINFECTING
M P
ASK BETWEEN
NV F F M
IRAGE ULL ACE ASK
ResMed cannot give any assurance
Detach the mask from the ventilator. Disassemble
the mask by separating the headgear, luer lock port
caps, cushion clip, mask cushion, and forehead pad
clip assembly (if attached).
After disassembly, thoroughly clean the mask
components according to the following cleaning
procedure:
/S
TERILIZING
ATIENTS
S 2. We advise that
ERIES
7