Mounting With The V-Mount Kit; Ni Tsm-101X Features; To 36 V Terminal Block; Vga Connector - National Instruments NI TSM-1012 User Manual

Mounting with the V-Mount Kit

You can use the V-Mount Kit to mount the NI TSM-1012 to a wall, ceiling, desk, or other
surface. The V-Mount has a 0 to 90 degree adjustable hinge to optimize the viewing angle of
the monitor.
Note The V-Mount is compatible only with the NI TSM-1012.
Take the following steps to mount the NI TSM-1012 with the V-Mount Kit.
1. Mark the locations of the four V-Mount retention screw holes on the mounting surface.
2. Align the VESA mounting holes in the V-Mount with the mounting holes in the rear of
the monitor.
3. Insert retention screws through the VESA mounting holes to secure the V-Mount to the
monitor.
Note
100.0 mm × 100.0 mm (3.94 in. × 3.94 in.) apart.
4. Secure the V-Mount and monitor to the surface with retention screws in the locations you
marked in step 1.

NI TSM-101x Features

9 to 36 V Terminal Block

The 9 to 36 V DC terminal block has an earth ground socket, a ground socket, and three
terminals for 9 to 36 V inputs.
9V~36V DC
POWER INPUT

VGA Connector

The VGA connector connects VGA video output from the host machine into the monitor. The
pins on the connector have the standard pin numbering configuration for a VGA connector.
The VESA holes on the monitor are designed for M4 screws and set at
Figure 9. 3-pin Terminal Block
GND 9V~36V
NI TSM-101x User Manual | © National Instruments | 13
CONNECT TO
EARTH GROUND