Panel Mounting - National Instruments NI TSM-1012 User Manual

4-RIO
341.40 mm

Panel Mounting

The NI TSM-101x monitor has a series of mounting slots on the top and bottom panel, and
requires nine mounting clamps to mount to a panel.
Take the following steps to mount the NI TSM-101x to a panel:
1. Cut out a section of the panel that corresponds to the dimensions of the rear panel of the
monitor as shown in the following table.
Model
NI TSM-1012
NI TSM-1015
NI TSM-1017
2. Slide the monitor through the cutout until the aluminum frame is flush against the panel.
3. Secure the panel mounting brackets to the rear of the monitor. Insert the panel mounting
clamps into the holes along the two edges of the panel mounting brackets. The following
figure shows the panel mounting clamp positions.
10 | ni.com | NI TSM-101x User Manual
Figure 6. NI TSM-1017 Dimensions
374.30 mm
Table 2. Suggested Cutout Dimensions
Height
243.8 mm (9.60 in.)
284.6 mm (11.20 in.)
323.0 mm (12.72 in.)
408.40 mm
340.00 mm
49.30 mm
Width
303.8 mm (11.96 in.)
360.1 mm (14.18 in.)
390.0 mm (15.35 in.)