Configuring And Installing; General Requirements - Siemens SIMOTION C Operating Instructions Manual

Configuring and installing

4.1

General requirements

Overview
In this chapter we will explain how to design the mechanical configuration, prepare the
SIMOTION components for installation and install them.
During the installation of SIMOTION C modules, you must pay attention to the electrical
configuration. Therefore, also refer to the chapter Wiring (Page 91).
Open equipment
These modules are open equipment. This means they may only be installed in housings,
cabinets or in electrical service rooms that can be entered or accessed exclusively by means
of a key or tool. Housings, cabinets or electrical service rooms may only be accessed by
trained or authorized personnel.
SIMOTION C
Operating Instructions, 02/2012
4
77