Commissioning; Requirements For Commissioning - Siemens SIMOTION C Operating Instructions Manual

Commissioning

7.1

Requirements for commissioning

Requirements
Table 7- 1 Requirements
Prerequisite action
Your system with SIMOTION C is installed.
Your system with SIMOTION C is wired.
For networking via PROFIBUS DP
The PROFIBUS addresses of the bus nodes with which the

SIMOTION C communicates, are set.
The terminating resistors are switched on (at segment ends).

When networking via the Ethernet, the IP address / subnet mask of the
bus nodes with which the SIMOTION C communicates, are set.
When networking via PROFINET IO, the PROFINET device names of the
bus nodes with which the C240 PN communicates, are set
System requirements
Note
The readme file for the software version you are using provides information about the
hardware and software requirements.
Please take note of the information on the current CD for "SIMOTION SCOUT"!
For online operation, a connection must be established between the PG/PC and the
SIMOTION C via PROFIBUS DP, Ethernet or PROFINET (C240 PN), see chapter Overview
of wiring diagram (Page 94).
The programming device must be equipped with a PROFIBUS or Ethernet card.
You need an MMC adapter to write to the micro memory card (SIMOTION Kernel update) on
the PG/PC, see chapter Writing, formatting and erasing the Micro Memory Card (Page 147).
SIMOTION C
Operating Instructions, 02/2012
See ...
ChapterInstalling (Page 84)
ChapterWiring (Page 91)
ChapterNetworking (Page 122)
ChapterConfiguring an Ethernet subnet on the
Ethernet interface (Page 127)
ChapterConfiguring an Ethernet subnet on the
PROFINET interface (C240 PN) (Page 129)
7
143