Ruggedcom Rox Ii Actions - Siemens RX1400 Reference Manual

RUGGEDCOM NETCONF
Reference Guide

RUGGEDCOM ROX II Actions

This section describes how to activate RUGGEDCOM ROX II actions on the device with an <rpc> message through
NETCONF. Actions perform functions directly on the device, such as shutting down the device, rebooting, clearing
port statistics, and more.
To activate most actions, the <rpc> simply specifies the path to the action in the RUGGEDCOM ROX II data model.
Some actions require parameters, such as module and port numbers, object identifiers, and other settings. Where
required, this section describes the parameters for each action.
This section organizes the actions by the RUGGEDCOM namespace in which the actions are found.
Table: Actions and RUGGEDCOM ROX II Web Interface Equivalents
Action
Section 6.1.1, "snmp-discover"
Section 6.1.2, "launch-upgrade"
Section 6.1.3, "decline-upgrade"
Section 6.1.4, "rollback-reboot"
Section 6.1.5, "roxflash"
Section 6.1.6, "clear-all-alarms"
Section 6.1.7, "acknowledge-all-alarms"
Section 6.1.8, "shutdown"
Section 6.1.9, "reboot"
Section 6.1.10, "set-system-clock"
Section 6.1.11, "restore-factory-defaults"
Section 6.1.12, "delete-logs"
Section 6.1.13, "install-files"
Section 6.1.14, "backup-files (Backup Files)"
Section 6.1.15, "full-configuration-save"
Section 6.1.16, "full-configuration-load"
Section 6.2.5, "reset (Serial Port)"
Section 6.2.6, "clear-serial-port-stats"
Section 6.2.7, "restart-serserver"
Section 6.2.8, "reset-port (Switch Port)"
Section 6.2.9, "clear-port-stats (Switch Port)"
Section 6.2.10, "start-cable-test (Switch Port)"
Path to Action in RUGGEDCOM ROX II
admin » snmp » snmp-discover
admin » software-upgrade » launch-upgrade
admin » software-upgrade » decline-upgrade
admin » software-upgrade » rollback-reboot
admin » rox-imaging » roxflash
admin » clear-all-alarms
admin » acknowledge-all-alarms
admin » shutdown
admin » reboot
admin » set-system-clock
admin » restore-factory-defaults
admin » delete-logs
admin » install-files
admin » install-files
admin » full-configuration-save
admin » full-configuration-load
interfaces » serial » port{interface} » reset
interfaces » serial » port{interface} » clear-serial-port-stats
interfaces » serial » restart-serserver
interfaces » switch{interface} » reset-port
interfaces » switch{interface} » clear-port-stats
interfaces » switch{interface} » diagnostics » start-cable-test
Chapter 6
RUGGEDCOM ROX II Actions
53