Locating Safe-T-Beam® Pairs; Wire Diagram - Genie 2562 Maintenance Manual
Belt/chain/screw drive garage door opener
Hide thumbs
Also See for 2562:
- Programming, operation & maintenance manual (4 pages) ,
- Assembly & installation (8 pages) ,
- Assembly/installation instructions (2 pages)
Table of Contents
Advertisement
MAINTENANCE & ADJUSTMENTS
LOCATING SAFE-T-BEAM® PAIRS
Transmitter (RED LED) and Receiver (GREEN LED)
Single Garage Door
• Determine which side of the garage receives direct sunlight.
• Position the Transmitter (Red LED) on the direct sunlight side.
NOTE: Only use Safe-T-Beams® that are included with this opener. DO NOT use other
brands or types of photocells on this opener.
WARNING
AVERTISSEMENT
CHOC ÉLECTRIQUE
OUVERTURE DE COUVERTURE
PEUT PROVOQUER
CHOC ÉLECTRIQUE.
Coupez l'alimentation du
premier match avant de retirer
le couvercle.
16
Multiple Garage Doors
• NEVER position Safe-T-Beam® modules where signals will cross.
• Place the Transmitter (Red LED) Safe-T-Beams on adjacent doors
facing in opposite directions.
NOTE: Direct sunlight creates interference with Safe-T-Beam
Receiver (Green LED). STB modules CAN be positioned further
away from the door opening if necessary to avoid sunlight
but no further o the wall to maintain alignment with the
Transmitter (Red LED) module.
WIRE DIAGRAM
®
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
