Initial Turn Up; Recommended Turn Up Order - Uniden Pro12800N0-4K Installation Manual

INITIAL TURN UP

RECOMMENDED TURN UP ORDER

INITIAL SYSTEM SETUP
In the Guide (see page 18), set:
• Default Language
• Display Resolution (Default - 1920 x 1080)
• LAN1 and LAN2 Network Settings
_______
When finished, select Next time no longer display and click Finish .
Go to System/Time Setting, Device Time tab (see page 19) and set:
• Device Time
• Date Format
• Time Zone
_______
• Enable Daylight Savings Time and set start and end dates .
• Network Time Protocol (NTP) is enabled by default . Change to internal time source
if desired (see page 19) . Turn off if the customer does not want the recorder to go
out on the internet .
_______ The recording schedule default is for all cameras to record all the time (Channel
Setting/Schedule Setting/Recording Setting). Set up specific recording schedules (see
page 20) .
_______ From System Setting/User Management, set up new users and change the Admin
password (see page 19) .
_______ From System Setting/Alarm Management/Alarm Input (or Alarm Output) top tab, set
up alarm inputs and outputs (see page 22) .
_______ From System Setting/Network Parameter/Email Setting top tab, set up email
notification (see page 23).
_______ From System Setting/Network Parameters/DDNS Setting top tab select Enable DDNS
to set up remote DDNS access (see page 24) .
_______ From Maintenance/System Information/Device Information top tab, update firmware if
desired (see page 25) . (The device will automatically reboot after upgrade .)
HARD DISK DRIVE (HDD) SETUP
_______ Go to Disk Manager/Storage Management and uncheck Missing Alarm for all non-
installed HDDs (see page 25) .
_______ From Disk Manager/Storage Management, verify HDD quantity and sizes (see page
26) . Shut down and add HDDs if needed .
Set up Redundent Array of Independent Disks (RAID) array (for systems 36 channels
or greater) (see page 26) .
• Set up RAID type and format .
_______
• Assign cameras to HDDs/RAID .
NOTE: Pre-installed HDDs are factory-formatted and ready for use.
ADD IP CAMERAS
_______ Plan and set up IP addresses (see page 29) .
_______ Add IP cameras (see page 29) .
Change IP address of each camera to put it in the same range as the network
connector (LAN1 or LAN2) that the camera is connected to (see page 29) . Connect
Success displays .
_______ Add Channels to Preview Groups
From Channel Setting/Channel Grouping, set up Preview Groups (see page 31
16
ProSeries NVR Installation Guide Only 03162018.indd 16-17
_______ From Channel Setting/Channel Grouping/Tour (right column), set up Tour Groups if
desired (see page 31) .
_______ Check and adjust camera images for focus and field of view in Preview (see page
33) .
_______ From Preview, set up PTZ Presets (page 33), Cruise (page 34 if applicable), and
Pattern (page 34 if applicable) .
Set individual camera settings for each channel if desired (see page 35):
Other areas to set up include but are not limited to:
• Motion Detection (From Channel Setting/Channel Parameter/Motion top tab, page
37)
_______
• Privacy Mask (From Channel Setting/Channel Parameter/Privacy Mask tab,
• page 38)
• Snapshot Parameters (From Channel Setting/Channel Parameter/Snapshot
Parameters tab, page 37)
• Video Tampering (From Channel Setting/Channel Parameter, Video Tampering
tab, page 39
17
3/26/2018 10:32:35 AM