Table of Contents
Advertisement
2 . Select Save, then click Exit to return to the Recording Setting screen .
3 . Go to Channel Setting/Channel Parameter/Motion tab . For each channel:
• Enable Motion Detection
• Select Full Screen . A red grid displays . This grid shows the areas that WILL trigger motion
detection. If you only want a specific area of the camera's view to trigger motion detection,
select Clear all, then click and drag the curser over the area you want to trigger recording .
This creates a specific red grid. Everything outside of the red grid will NOT trigger motion
detection .
4 . Click Save .
5 . If you want to copy that channel's settings to another channel, Click Copy to at the bottom of
the screen . The Copy to popup screen displays
6 . Uncheck the options you don't want to copy. Select All (copy to all channels) or select specific
channels . Click Confirm and the Motion tab screen displays again .
SET UP ALARM INPUTS/OUTPUTS
Alarm Inputs
1 . Go to System Setting/Alarm ManagementAlarm Input, top tab .
22
ProSeries NVR Installation Guide Only 03162018.indd 22-23
2 . Complete the fields. Click Save if your are finished. Click Copy To to copy the setting to other
channels . The Copy To screen displays .
3 . Uncheck the options you don't want to copy. Click All (copy to all channels) or select specific
channels . Click OK and the Alarm Input tab screen displays again .
Alarm Outputs
1 . Go to System Setting/Alarm Management/Alarm Output top tab .
2 . Complete the fields. Click Save if your are finished. Click Copy To to copy the settings to other
channels, and then click Save when finished.
SET UP EMAIL NOTIFICATION
1 . Go to System Setting/Network Setting/Email Setting top tab . The Email setting screen displays .
23
3/26/2018 10:32:43 AM
Advertisement
Table of Contents
