Table of Contents
Advertisement
the right side with a channel number . Follow these guidlines:
•
4K cameras - select the IPC with the SLINK protocol (Proto . column) .
•
IPCs included in a NVR kit - select the I8S protocol for these IPCs .
•
IPCs that show I8H - use this protocol if the above don't apply.
•
IPCs that only show I8 - use this protocol if none of the above don't apply.
•
If you are not using a Uniden IPC, select the Onvif protocol .
•
If the IPC does not show up, check the IP address and the network, and try again .
3 . When the IPC shows up on the right side, it will automatically be assigned the next channel
number . After a few seconds, the Status column should display Connect success for each
channel . f not, make sure the IPC and the LAN are in the same IP range .
4 . On the left side, double left-click the IP address to display the IPS Details window . Review IP
address and Subnet Mask . If anything needs to change, click Modify, then Confirm, and finally
Exit . Close the window and return to the Channel Connecting screen .
5 . From Channel Setting/Channel Parameter/Display Setting, select a channel in the Channel
drop down list . Check the Show Local Channel Name box to create a name to display for that
channel (un-check this box if you do not want the name to show up in the picture) .
6 . After all cameras are connected and working, go to the Preview screen and show all cameras .
You can put the cameras in whatever display order you want . With the mouse, click and drag
a camera from its current layout location and drop it in another location to swap locations .
Confirm the swap in the pop-up confirmation screen.
SET UP CHANNEL GROUPS
You can name your channels and then put them into collections called groups . For example, if
you have named three channels Foyer, Front Door, and Front Parking, you can create a group
called Front Entrance and then add the channels to that group . When you need to check the front
entrance, view that channel group through Preview .
Name Channels
1 . Go to Channel Setting/Channel Parameter/Display Setting tab . Enter a name for that channel
and any other parameters as desired .
2 . Click Save, then Exit .
3 . Repeat for other channels .
30
ProSeries NVR Installation Guide Only 03162018.indd 30-31
Create a Preview Group
1 . From Channel Setting/Channel Grouping/Preview groups tab, select
Setting window displays .
2 . Click inside the Group Name field and popup keyboard displays. Enter a name for the group,
select the return arrow, and click Confirm .
3 . The new preview group displays on the right side .
Assign Channels to the Preview Group
1 . From Channel Setting/Channel Grouping/Preview groups tab, select a Preview group on the
right side to add cameras to .
2 . On the left side, select the channels to add . Click >>> to add the channels to the selected
Preview group . These channels now display under that group .
SET UP CAMERA TOURS
You can set up the system to automatically display the cameras in a specific order. This order is
called a tour . You can set up multiple tour groups . From the Preview screen, select the Tour icon
(
) at the bottom of the screen to turn Tour on and off . When Tour is on, the icon turns blue .
1 . Go to Channel Setting/Channel Grouping/Preview Sequences tab .
2 . Select + to add a tour group . The Group Name Setting screen displays .
. The Group Name
+
31
3/26/2018 10:32:46 AM
Advertisement
Table of Contents
