Hach HQ11d User Manual page 32

Figure 15 Total report for sample data—3 lines
1 Method name for probe settings
2 Time of calibration, prefaced by "CAL" and displayed as hh:mm in 24 h (or user-
defined) format
3 Date of calibration (DD-MM-YY or user-defined format)
Check standard reports
Check standard data is printed with 1 line of information
Figure 16 Check standard report
1 Report type (ST = check standard)
2 Report type (ST = check standard)
3 Time (hh:mm:ss in 24 h or user-defined format)
4 Date (DD-MM-YY or user-defined format)
Calibration reports
Calibration data is printed when the data log is sent to the printer or when probe data is sent to the printer. Calibration data is printed with 2 lines of
information (Figure 17).
30 English
4 Calibration slope/ratio/constant
5 Offset—contents vary depending on type of parameter and user settings. May
be blank.
6 Operator ID: user-defined; shows "- - -" if undefined
(Figure 16)
5 Measured value
6 Units
7 Check standard status: Pass/Fail based on the acceptance criteria
8 Operator ID: user-defined; shows "- - -" if undefined