Hach HQ11d User Manual page 19

Table 1 Spreadsheet column descriptions (continued)
Column header name Data description and example values
Check Std Value Value of the check standard that was used to verify
accuracy, for example: 7.00 pH–25 ºC (pH, temp-
compensated); 7.01 pH (pH, custom)
Check Std Units Check standard units, for example μS/cm.
Note: pH is not displayed here as it is included in the previous
column.
Check Std Graph Bar-graph showing the measurement in relation to the
acceptance limits. Example: "6.901 <—|—> 7.101".
Check Std Status Status of the check standard reading. Example:
"Reading within limits", "Reading outside limits"
Calibration Status
Status of the calibration that is in use.
calibration is valid;
Cal Date Date of calibration reading: stored in user-defined date
format
Cal Time Time of calibration reading: stored in user-defined
time format
Cal Operator ID The operator ID specified when the probe was
calibrated. Shows "- - -" if undefined.
Cal Slope Name Slope (pH or LDO) or cell constant (conductivity)
Cal Slope The slope value for the calibration
Cal Slope Aux Used by pH to give the percent of nominal slope
Cal Slope Units Units of the calibration slope. Example: "mV/pH" for
pH
Cal Offset Calibration offset value
Cal Offset Units Calibration offset units. Example: "mV" for pH.
Cal r² Calibration correlation coefficient without a unit (may
be blank)
= current
= calibration has expired.
Table 1 Spreadsheet column descriptions (continued)
Column header name Data description and example values
Cal Number of Std's Number of standards used during calibration, for
example 5. May be blank depending on record type,
parameter type, and method settings.
Cal Std 1 Known value of the first calibration standard
Cal Std 1 Units Units of the first calibration standard
Cal Std 1 Primary Value Measured value of the first calibration standard
Cal Std 1 Primary Units Associated units for the calibration measurement
Cal Std 1 Supp Value Value of supplemental measurement, for example
temperature
Cal Std 2–7 Known value of additional calibration standards, if
used
Cal Std 2–7 Units Units of additional calibration standards, if used
Cal Std 2–7 Primary Measured values of additional calibration standards, if
Value used
Cal Std 2–7 Primary Associated units for additional calibration
Units measurements, if used
Cal Std 2–7 Supp Value Value of supplemental measurement, for example
temperature
Cal Std Supp Units Units applicable to all secondary calibration readings.
Example: "ºC" or "ºF" for temperature
Cal Message 1–4 Any messages about the calibration
Date/Time POSIX Date and time of reading stored in POSIX format
(number of seconds from January 1, 1970) Example:
1149234913
Cal Date/Time POSIX Date and time of calibration stored in POSIX format
(number of seconds from January 1, 1970). Example:
1111320348
Meter SN Meter serial number used to take the measurement
English 17