7.2.2
Installing the fan/battery module
Overview
The procedure for installing the double fan/battery module is described below.
Procedure
There are cutouts on the lower side of the control unit to attach the module. Proceed as follows
to install the double fan/battery module:
1. If required, insert a battery in the double fan/battery module.
2. Hold the double fan/battery module at an angle to the front with the open side facing up.
3. Push the plastic lug into the slot-like cutout on the lower side of the control unit.
4. Tilt the double fan/battery module up until the two latches snap into place at the front. Note
7.2.3
Replace battery in the fan/battery module
Overview
The procedure for replacing the double fan/battery module's battery is described below.
SIMOTION D4x5-2
Manual, 04/2014
The battery must be visible.
the two contact strips that are lead through cutouts of the control unit.
This establishes the electrical connection between the double fan/battery module and the
control unit.
Figure 7-2
Installing the double fan/battery module
Supplementary system components
7.2 Fan/battery module
99