Slot For Compactflash Card; Measuring Sockets - Siemens SIMOTION D425-2 Manual

4.8

Slot for CompactFlash card

Characteristics
Connector type: 50-pin connector
This interface should only be used to insert a special SIMOTION CompactFlash card (CF card).
Figure 4-9
Consult the relevant references for detailed information about the SIMOTION CompactFlash
card in Section CompactFlash card (Page 39).
4.9

Measuring sockets

Application
The measuring sockets X141 (T0, T1 and T2) are on the lower side of the module and are
used to output analog signals. Any interconnectable signal can be output via SINAMICS on
every measuring socket on the control unit.
SIMOTION D4x5-2
Manual, 04/2014
Slot for the CompactFlash card
Interfaces
4.9 Measuring sockets
73