Assembly; Fitting The Blade Guard - Ryobi EMS2305SCL Owner's Operating Manual

EMS2305SCL MANUAL 29/4/05

FITTING THE BLADE GUARD.

WARNING : Failure to unplug your saw could result in accidental starting causing
possible serious personal injury.
Fig. 1 cover plate screw
guard screw
• Unplug the saw from the outlet. Ensure the cutting head is up to its full extent.
• Loosen the cover plate stop screw (Fig 1) and take note of where guard
screw (supplied with loose parts) is to be located.
• Fit the guard around the blade and ensure the cover plate of the guard is
located over the cover plate stop screw.
• Fit the guard screw and tighten before tightening the cover plate stop screw.
• Position the connecting bar to the back of the unit and use the screw pivot
point to fix the bar to the saw (Fig 2). The saw head may need to be moved
up and down slightly in order to correctly locate the screw.
1:54 PM Page 5

ASSEMBLY

Fig. 2