Reebok EXERCISE CYCLE RBEX3976.0 User Manual page 5

2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (16) to the Frame with four
M8 x 50mm Button Screws (52) and four M8 Split
Washers (55).
3. Tighten the Upright Knob (7) into the Frame (1).
4. While another person holds the Upright (2) near the
Frame (1), use the wire tie in the Upright to pull the
Upper and Main Wire Harnesses (42, 43) through the
Upright. See the inset drawing. Tie the wire tie to the
ends of the Wire Harnesses. Then, pull the other end
of the wire tie upward out of the top of the Upright.
Attach the Upright (2) to the Frame (1) with an M10 x
63mm Bolt Set (62). Be careful to avoid pinching the
Wire Harnesses (42, 43).
5. The Console (4) requires four "D" batteries (not includ-
ed); alkaline batteries are recommended. Remove the
battery cover from the back of the Console. Next,
insert four batteries into the battery compartment;
make sure that the batteries are oriented as shown
by the diagram inside the battery compartment.
Then, reattach the battery cover.
2
1
16
3
7
4
Avoid pinching
and damaging
the wires.
2
62
5
Batteries
4
5
55
55
52
52
1
42
43
Wire Tie
62
42, 43
1
Batteries
Battery
Cover