Mounting the Router
Step 1
Step 2
Step 3
Configuring the Router
Checking the PC Configuration
Cisco 836 Router and SOHO 96 Router Hardware Installation Guide
2-46
1
Two number-six, 3/4-in. screws
2
Distance between the two screws
(7 5/8 in. [19.35 cm])
3
Cisco 836 router
4
Mounting brackets
Perform the following steps to mount the router on the wall:
Secure two screws 7 5/8 inches (19.35 centimeters) apart into a wall and 1/8 inch
(0.32 centimeter) from the wall.
Hang the router on the screws as shown in Figure 2-8.
Place the power supply on a horizontal surface.
When you finish installing the router, you must configure the router software.
First, check the PC configurations to ensure that all the connected PCs will be able
to communicate with the router. Then configure the router software, using the web
interface.
Each PC that is connected to the router must be configured to use TCP/IP and to
obtain its IP address automatically. Follow these steps to configure each PC that
is running Microsoft Windows NT or Microsoft Windows 95, 98, 2000, Windows
ME, and Windows XP. If the PC is running a different version of Microsoft
Windows, refer to the documentation that came with the PC.
Chapter 2
5
Maximum distance between the
router and the power supply (6 ft
[1.8 m])
6
Horizontal surface for placing the
power supply
7
Distance between the screw and
the wall (1/8 in. [0.32 cm])
Installation
78-15281-02