Table of Contents
Advertisement
®
ABB i-bus
EIB / KNX
28
Commissioning
Sensor output
Options:
0 – 1 V/0 – 5 V/0 – 10 V/1 – 10 V
0 – 20 mA/4 – 20 mA/0 – 1000 ohm/
Floating contact interrogation /
PT100 2-conductor technology – 30...+ 70 °C/
PT100 2-conductor technology – 200...+ 800 °C
This parameter is used to set the Sensor output. The data can be found
in the technical documentation of the sensor manufacturer.
Send output value as
This parameter is fixed as 2 byte [EIB floating point].
Temperature offset in 0.1 K [– 50...+ 50]
Options:
– 50...0...+ 50
An additional maximum offset of + /– 5 K (Kelvin) can be added to
the recorded temperature using this parameter.
Line fault compensation
Options:
non/via cable length/via cable resistance
This parameter is used to set a Line fault compensation to compensate
for the measuring error caused by the cable resistance.
In the case of the via cable length and via cable resistance options, further
parameters appear – see next page.
Advertisement
Table of Contents
