Cisco 2800 Series Manual page 171

Hoot and Holler over V3PN Configuration Example
outbound ah sas:
outbound pcp sas:
The following is an output example for the show ip ospf neighbor command, performed using the
configuration on the Branch 1 router:
Branch-1# show ip ospf neighbor
Neighbor ID
192.168.1.1
The following is an output example from the show ip route command, performed using the
configuration on the Branch 1 router:
Branch-1# show ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
Gateway of last resort is 10.32.153.33 to network 0.0.0.0
192.168.4.0/32 is subnetted, 1 subnets
O
O 192.168.5.0/24 [110/21] via 192.168.1.1, 00:33:28, Tunnel0
10.0.0.0/8 is variably subnetted, 3 subnets, 2 masks
C
C
O 192.168.6.0/24 [110/11] via 192.168.1.1, 00:33:28, Tunnel0
C 192.168.7.0/24 is directly connected, Vif1
O 192.168.1.0/24 [110/11] via 192.168.1.1, 00:33:28, Tunnel0
C 192.168.2.0/24 is directly connected, FastEthernet0/0
O 192.168.3.0/24 [110/21] via 192.168.1.1, 00:33:28, Tunnel0
S* 0.0.0.0/0 [1/0] via 10.32.153.33
The following is an output example for the show ip pim neighbor command, performed using the
configuration on the Branch 1 router:
Branch-1# show ip pim neighbor
PIM Neighbor Table
Neighbor
Address
192.168.1.1
The following is an output example for the show ip pim rp mapping command, performed using the
configuration on the Branch 1 router:
Branch-1# show ip pim rp mapping
in use settings ={Tunnel, }
slot: 0, conn id: 5152, flow_id: 32, crypto map: INT_CM
crypto engine type: Hardware, engine_id: 2
sa timing: remaining key lifetime (k/sec): (508938172/10695)
ike_cookies: 795753FB 41D07F6D DE2C7D5A FB6197B3
IV size: 8 bytes
replay detection support: Y
Pri State
0 FULL/ -
192.168.4.1 [110/11] via 192.168.1.1, 00:33:28, Tunnel0
10.32.153.33/32 is directly connected, Virtual-Access4
10.32.153.32/30 is directly connected, Virtual-Access3
is directly connected, Virtual-Access4
Interface
Tunnel0
Dead Time Address
00:00:35 192.168.1.1
Uptime/Expires
00:20:59/00:01:25 v2
Verify
Interface
Tunnel0
Ver DR
Prio/Mode
1 / S
OL-6573-01
31