Verify Remote Location Connectivity; Verifying Branch 1 Router - Cisco 2800 Series Manual

Hide thumbs Also See for 2800 Series:
Table of Contents

Advertisement

Hoot and Holler over V3PN Configuration Example

Verify Remote Location Connectivity

This section provides instructions for verifying that your configuration works properly.
Certain show commands are supported by the Output Interpreter Tool (registered customers only),
which allows you to view an analysis of show command output.
In general, the show commands that are used to verify remote location connectivity are the same as the
commands used for the Headquarters router. See the
page 17
verification. The following commands are used for the remote locations only:
Representative output for each of these commands is presented in the verification summaries that follow.
Relevant display output is highlighted in
Note
Example output is split into two sections:

Verifying Branch 1 Router

The following is an output example for the show crypto isakmp sa command, performed using the
configuration on the Branch 1 router (DSL):
Branch-1# show crypto isakmp sa
dst
10.32.152.26
3 DES:
AES CBC:
AES CNTR:
Maximum buffer length:
Maximum DH index:
Maximum SA index:
Maximum Flow index:
Maximum RSA key size:
crypto engine name:
crypto engine type:
serial number:
crypto engine state:
crypto engine in slot:
for summaries of the show commands that are common to both Headquarters and branch
show policy-map interface virtual-access 4 output—Shows how traffic has been queued on the
DSL interface (Branch 1). Note that different queues have different packet counts because traffic is
assigned on the basis of DCSP and IP precedence values.
show policy-map interface serial 0/0/0 output—Shows how traffic has been queued on the serial
interface (Branch 2). Note that different queues have different packet counts because traffic is
assigned on the basis of DCSP and IP precedence values.
Verifying Branch 1 Router, page 27
Verifying Branch 2 Router, page 34
src
10.32.153.34
Yes
Yes (128,192,256)
No
4096
0500
0500
1000
2048
Cisco VPN Software Implementation
software
77C943AD
installed
N/A
"Verify Headquarters Connectivity" section on
text.
bold
state
conn-id slot
QM_IDLE
4
0
OL-6573-01
Verify
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents