Cisco 2800 Series Manual page 177

Hoot and Holler over V3PN Configuration Example
The following is an output example for the show ip ospf neighbor command, performed using the
configuration on the Branch 2 router:
Branch-2# show ip ospf neighbor
Neighbor ID
192.168.1.1
The following is an output example for the show ip route command, performed using the configuration
on the Branch 2 router:
Branch-2# show ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
Gateway of last resort is 10.32.150.45 to network 0.0.0.0
192.168.4.0/32 is subnetted, 1 subnets
O
C 192.168.5.0/24 is directly connected, Vif1
10.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
C
O 192.168.6.0/24 [110/11] via 192.168.1.1, 00:31:10, Tunnel0
O 192.168.7.0/24 [110/21] via 192.168.1.1, 00:31:10, Tunnel0
O 192.168.1.0/24 [110/11] via 192.168.1.1, 00:31:11, Tunnel0
O 192.168.2.0/24 [110/21] via 192.168.1.1, 00:31:11, Tunnel0
C 192.168.3.0/24 is directly connected, FastEthernet0/0
S* 0.0.0.0/0 [1/0] via 10.32.150.45
The following is an output example for the show ip pim neighbor command, performed using the
configuration on the Branch 2 router:
Branch-2# show ip pim neighbor
PIM Neighbor Table
Neighbor
Address
192.168.1.1
The following is an output example for the show ip pim rp mapping command, performed using the
configuration on the Branch 2 router:
Branch-2# show ip pim rp mapping
PIM Group-to-RP Mappings
Group(s) 224.0.0.0/4
RP 192.168.4.1 (?), v2v1
Info source: 192.168.4.1 (?), elected via Auto-RP
The following is an output example for the show ip mroute active command, performed using the
configuration on the Branch 2 router:
Branch-2# show ip mroute active
Active IP Multicast Sources - sending >= 4 kbps
Pri State
0 FULL/ -
192.168.4.1 [110/11] via 192.168.1.1, 00:31:10, Tunnel0
10.32.150.44/30 is directly connected, Serial0/0/0
is directly connected, Serial0/0/0
Interface
Tunnel0
Uptime: 2d03h, expires: 00:02:47
Dead Time Address
00:00:37 192.168.1.1
Uptime/Expires
00:31:52/00:01:26 v2
Verify
Interface
Tunnel0
Ver DR
Prio/Mode
1 / S
OL-6573-01
37