BenQ LH770 User Manual page 45

7. IP Address, Subnet Mask, Default Gateway and DNS Server settings will appear. Record the
IP address displayed in IP Address line.
Contact your ITS administrator if the IP address still has not appeared.
3. Go to the SYSTEM SETUP: Advanced > Network Settings menu.
9. Press ▼ to highlight AMX Device Discovery and press ◄/► to select On or Off. When AMX
Device Discovery is On, the projector can be detected by AMX controller.
In the non-DHCP environment:
1. Repeat steps 1-4 above.
2. Highlight DHCP and press ◄/► to select Off.
3. Contact the ITS administrator to find out information on IP Address, Subnet Mask, Default
Gateway and DNS Server settings.
4. Press ▼ to select the item you want to modify and press MODE/ENTER.
5. Press ◄/► to move the cursor and press ▲/▼ to enter values.
6. Press MODE/ENTER to save the setting. Press MENU/EXIT if you don't want to save the setting.
7. Press ▼ to highlight Apply and press MODE/ENTER.
8. Press MENU/EXIT to return to the Network Settings page. Press ▼ to highlight AMX Device
Discovery and press ◄/► to select On or Off.
9. Press MENU/EXIT leave the menu.
Wired LAN
Status
DHCP
IP Address
Subnet Mask
Default Gateway
DNS Server
Apply
Wired LAN
Status
DHCP
IP Address
Subnet Mask
Default Gateway
DNS Server
Apply
IP Address
Connection
On
MENU EXIT
Connection
On
MENU EXIT
45