Configuring Mpls Te Over Bdi - Cisco ASR 920 Series Configuration

MPLS Traffic Engineering over Bridge Domain Interfaces

Configuring MPLS TE over BDI

SUMMARY STEPS
1. enable
2. configure terminal
3. interface bdi30
4. mpls traffic-eng tunnels
5. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2 configure terminal
Example:
Router# configure terminal
Step 3
interface bdi30
Example:
Router(config)# interface bdi30
Step 4 mpls traffic-eng tunnels
Example:
Router(config-if)# mpls traffic-eng tunnels
Step 5
end
Example:
Router(config-if)# end
MPLS Traffic Engineering Path Calculation and Setup Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR
Configuring MPLS TE over BDI
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters interface configuration mode.
Specifies the bridge domain interface and enters interface
configuration mode.
Enables an MPLS TE tunnel to use an established tunnel
for the bridge domain interface.
Returns to privileged EXEC mode.
920 Series)
45