Cisco ASR 920 Series Configuration page 11

Aggregation services router
Hide thumbs Also See for ASR 920 Series:
Table of Contents

Advertisement

MPLS Traffic Engineering – Bundled Interface Support
! Configure GEC interface
Device(config)# interface GigabitEthernet 0/0/2
Device(config-if)# no ip address
Device(config-if)# channel-group 1 mode active
Device(config-if)# exit
The show mpls traffic-eng tunnels command output displays information about a tunnel or one–line
information about all tunnels configured on the device:
Device# show mpls traffic-eng tunnels tunnel 14
Name: ASR1013_t14
Status:
Admin: up
path option 1, type explicit toR4overR3R3 (Basis for Setup, path weight 3)
Config Parameters:
Bandwidth: 0
Metric Type: TE (default)
AutoRoute: enabled
auto-bw: disabled
Active Path Option Parameters:
State: explicit path option 1 is active
BandwidthOverride: disabled
InLabel
OutLabel : Port-channel1, 1608
Next Hop : 172.16.1.2
FRR OutLabel : Tunnel23, 4868
RSVP Signalling Info:
RSVP Path Info:
My Address: 172.12.1.1
Explicit Route: 172.12.1.2 172.23.1.1 172.23.1.2 172.34.1.1
History:
Tunnel:
Time since created: 17 hours
Time since path change: 18 minutes, 22 seconds
Number of LSP IDs (Tun_Instances) used: 35
Current LSP: [ID: 35]
Uptime: 18 minutes, 22 seconds
Selection: reoptimization
Prior LSP: [ID: 32]
ID: path option unknown
Removal Trigger: signalling shutdown
Device# show mpls traffic-eng tunnels brief
show mpls traffic-eng tunnels brief
Signalling Summary:
LSP Tunnels Process:
Passive LSP Listener:
RSVP Process:
Forwarding:
Periodic reoptimization:
Periodic FRR Promotion:
Periodic auto-bw collection:
P2P TUNNELS/LSPs:
TUNNEL NAME
ASR1013_t14
On Mid Router:
P2P TUNNELS/LSPs:
TUNNEL NAME
ASR1013_t14
ASR1002F_t23
Example: Configuring MPLS TE - Bundled Interface Support over Gigabit Etherchannel
Oper: up
kbps (Global)
LockDown: disabled Loadshare: 0 [0] bw-based
:
-
Src 10.1.1.1, Dst 10.4.4.4, Tun_Id 14, Tun_Instance 35
172.34.1.2 10.4.4.4
MPLS Traffic Engineering Path Calculation and Setup Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR
(Tunnel10) Destination: 10.4.4.4
Path: valid
Signalling: connected
Priority: 7
7
Affinity: 0x0/0xFFFF
LockDown: disabled
Verbatim: disabled
running
running
running
enabled
every 3600 seconds, next in 3299 seconds
Not Running
every 300 seconds, next in 299 seconds
DESTINATION
UP IF
10.4.1.1
DESTINATION
UP IF
10.4.1.1
10.2.1.1
DOWN IF
STATE/PROT^M
-
Po12
DOWN IF
STATE/PROT
Po12
Po23
up/up
Po25
-
up/up
920 Series)
up/up
7

Advertisement

Table of Contents
loading

Table of Contents