Cisco ASR 920 Series Configuration page 36

Verifying the Configuration of MPLS Point-to-Multipoint Traffic Engineering
17 No Label
MAC/Encaps=0/0, MRU=0, Label Stack{}, via Ls0
Step 3 show ip mroute
Use the show ip mroute command to display IP multicast traffic. In the following example, the output in bold shows
the incoming interface is Lspvif0 and the outgoing interface is Ethernet1/0 is for multicast group 232.0.1.4 with source
address 10.10.10.10:
Example:
Router# show ip mroute
IP Multicast Routing Table
...
(*, 232.0.1.4), 1d02h/stopped, RP 0.0.0.0, flags: SP
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list: Null
(10.10.10.10, 232.0.1.4), 00:01:51/00:01:38, flags:
Incoming interface: Lspvif0, RPF nbr 10.0.0.1, Mroute
Outgoing interface list:
Ethernet1/0, Forward/Sparse, 00:01:51/00:02:37
(*, 224.0.1.40), 1d02h/00:02:57, RP 0.0.0.0, flags: DCL
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
Ethernet1/0, Forward/Sparse, 1d02h/00:02:57
MPLS Traffic Engineering Path Calculation and Setup Configuration Guide, Cisco IOS XE Release 3S (Cisco
ASR 920 Series)
32
10.0.0.1 1 [19] 342
MPLS Point-to-Multipoint Traffic Engineering
aggregate