Configuration Examples For Mpls Point-To-Multipoint Traffic Engineering; Example Configuration Of The Headend Router (Pe5) - Cisco ASR 920 Series Configuration

MPLS Point-to-Multipoint Traffic Engineering
Configuration Examples for MPLS Point-to-Multipoint Traffic
Engineering
The following examples show point-to-multipoint traffic engineering configurations on the headend router
(PE5), a midpoint router (P1), and a tailend router (PE1):
Figure 7: Sample MPLS TE P2MP TE Topology

Example Configuration of the Headend Router (PE5)

In the following example configuration of the headend router, note the following:
• IPv4 multicast routing is enabled with the ipmulticast-routing command.
MPLS Traffic Engineering Path Calculation and Setup Configuration Guide, Cisco IOS XE Release 3S (Cisco ASR

Configuration Examples for MPLS Point-to-Multipoint Traffic Engineering

920 Series)
33