Advertisement
Selecting the Best Location for
Multiple Window Coverage
The detector has a 360° coverage pattern that can be used to
cover several windows in a single room as follows:
• Draw an imaginary line from the center of each window to
be covered in towards the center of the room.
• Mount the detector as close to where the lines intersect as
possible. See Figure 3.
• Do not mount the detector at more than a 60° angle from
the center of any window to be protected. See Figure 3.
Installing the Detector
All wiring must conform to the National Electric Code (NEC)
and/or local codes having jursidiction.
Important !
If you are unsure about a location, connect a 9V
battery to the detector and test it before permanently
mounting. See Testing the Detector.
Use the following steps to install the detector:
1. Run the security system wiring to the detector location.
2. Remove the front cover as follows:
- Round housing Press the release tab on the lip of the
base, twist the cover counter clockwise, and lift off. See
Figure 4.
- Rectangle housing Insert a flat-blade screw driver into
the slot on the bottom of the cover and gently pry up to
unlock the cover. Grasp the bottom of the cover and lift up
until the cover latches in the open position. See Figure 6.
3. Set the range with J3 on the circuit board. See Setting
the Range.
4. Remove the appropriate wiring and mounting
knockout holes from the base. See Figure 6.
5. Pull the wires through the knockout holes and use two
screws to attach the base to the surface. Use wall anchors
if necessary.
6. Strip 3/8 inch of insulation from each wire.
7. Connect the system wires to the appropriate screw
terminals on the base and tighten the screws. See Figure 7.
8. Replace the cover as follows:
- Round housing Line up the tabs on the base with the
corresponding tabs on the cover, press together and turn
clockwise until the cover snaps firmly into place. See
Figure 5.
- Rectangle housing Press the cover back down over the
detector until the cover snaps firmly into place.
9. Apply power. The red LED should flash once.
10. Test the detector. See Testing the Detector.
2
Ceiling
mount
Detector
Figure 3 - Multiple Window Coverage
Release tab
Figure 4 - Round Housing Parts
Figure 5 - Attaching the Cover
Setting the Range
The detector provides a spring clip (J3) to set room size. See
Figure 6. Use the following table to determine what setting to
use for an application.
S
e
t t
n i
g
D
e
c s
i r
t p
o i
n
O
p
n e
U
e s
o f
r r
o o
m
s
5
o t
5 2
e f
t e
1 (
l C
s o
d e
U
e s
o f
r r
o o
m
s
r (
n a
e g
3
o t
0 1
60 max.
60 max.
Microphone
LED
1
0 0
s
u q
r a
f e
e e
a t
d n
a l
g r
r e
r (
5 .
m
o t
7
6 .
m
. ) )
D
e
a f
t l u
s
m
l a
r e l
h t
n a
1
0 0
q s
a u
e r
e f
t e
e f
t e
0 (
9 .
m
o t
3
m
. ) )
ShatterPro 3 Glassbreak Detector
n a
e g
Advertisement
