Mazda MX-5 2007 Bodyshop Manual page 7

• When there are no specific indications, the standard points and dimensions are symmetrical in regard to the
center of the vehicle.
• The hypothetical lines may differ according to the vehicle model.
• The schematic diagram shows the vehicle as it is projected from the underbody.
Example
Shows vehicle section
UNDERBODY FLAT-PLANE DIMENSIONS
Shows dimension
A
Shows hypothetical
standard line
420
{16.54}
Point
symbol
Crossmember No,1 standard
A
hole
B Front side frame standard hole
Front suspension mounting
C
block surface hole center
Front suspension mounting
D
bolt
Front frame rear standard hole
E
GENERAL INFORMATION
The dimensions on the left
and right in regard to the center
of the vehicle are different.
B C D E F G
182 93 144 120
1,030
{40.55}
{7.17} {3.66} {5.67} {4.72}
Hole diameter
or bolt or nut
Designation
size mm {in}
φ 16 {0.62}
φ 16 {0.62}
φ 80 {3.14}
M14 {0.55}
φ 16 {0.62}
Shows bolt size
When there are no specific indications, all of
units are in millimeters (mm).
Shows outline drawing
H I J
140 68
760
{5.51} {29.92} {2.68}
Point
Designation
symbol
F Front frame rear standard hole
Rear side frame standard hole
G
Link bracket
H
I Rear suspension housing
J
Rear side frame standard hole
K Rear suspension housing
L Rear side frame standard hole
Shows hole diameter
mm {in}
K L
Shows point
symbol
379
{14.92}
Hole diameter
or bolt or nut
size mm {in}
Shows
φ 18 {0.62}
slot
φ 16 {0.62}
17 × 29.5
{0.66×1.16}
φ 12 {0.47}
φ 16 {0.62}
φ 31 {1.22}
φ 12 {0.47}
DPE2010B003
00-00–5
00-00