Precaution; Specific Service Instructions; System Set-Up; Realignment - Kenwood NX-5400 Service Manual

This service manual does not describe PRECAUTION.
2.1

SYSTEM SET-UP

Merchandise received
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
Are you using the speaker microphone?
Are you using the secure cryptographic module?
Delivery
2.2

REALIGNMENT

2.2.1 Modes
User mode
Panel test mode Panel tuning mode
Data programming mode
PC mode
PC test mode
Firmware programming mode
Clone mode
Front panel programming mode*1
Transceiver information mode
*1:In order to use the Front panel programming mode, it is nec-
essary to purchase the "Front panel program" feature option.
1-4 (No.RA016<Rev.001>)
SECTION 1

PRECAUTION

SECTION 2

SPECIFIC SERVICE INSTRUCTIONS

A personal computer, programming interface (KPG-36U),
and FPU (programming software) are required for programming.
(The frequency, and signaling data are programmed for the transceiver.)
YES
NO
YES
NO
YES
NO
PC tuning mode
Frequency range (MHz) RF power
TX 763~775.99375
3W
793~805.99375
806~825 3W
851~870
3W
RX 763~775.99375
3W
851~870
KRA-32
Optional antenna
(Option)
KMC-41/KMC-42W/ * If the internal GPS function
KMC-54WD
is not used, the KMC-47GPS
Speaker microphone
(Option)
KWD-AE30/AE31 See pages 10 to 11.
(Option)
Mode
User mode For normal use.
Panel test mode Used by the dealer to check the fundamen-
tal characteristics.
Panel tuning mode Used by the dealer to tune the transceiver.
PC mode Used for communication between the
transceiver and PC.
Data programming Used to read and write frequency data and
mode other features to and from the transceiver.
PC test mode Used to check the transceiver using the
PC. This feature is included in the FPU.
Firmware program- Used when changing the main program of
ming mode the flash memory.
Clone mode Used to transfer programming data from
one transceiver to another.
Front panel pro- Frequency, signaling and features write to
gramming mode the transceiver.
Transceiver infor- Used to confirm the transcerver firmware
mation mode version, SCM firmware version and SCM
Hardware version.
Type DTMF keypad
NX-5400 F2 No
NX-5400 F3 Yes
NX-5400 K2 No
NX-5400 K3 Yes
can be used as GPS
speaker microphone.
Function