Kenwood NX-5400 Service Manual page 49

Item Condition
Panel tuning
mode
[NXDN 1) Adj item:
Very [Nv NDEV]
Narrow] Adjust:[****]
2) Adj item:
[Frequency:
700MHz Band]
[RX/TA Low]→
[RX/TA High]→
[TX Low]→
[TX High]
[Frequency:
800MHz Band]
[TX Low]→
[TX High]→
[RX/TA Low]→
[RX/TA High]
Adjust:[****]
PTT : ON
Press [ ] key to
store the adjust-
ment value.
11. QT 1) Adj item:
Devia- [Aw QT]
tion *3 Adjust:[****]
2) Adj item:
[Analog [Frequency:
Wide 700MHz Band]
5k] [RX/TA High]→
[TX High]
[Frequency:
800MHz Band]
[TX High]→
[RX/TA High]
Adjust:[****]
PTT : ON
Press [ ] key to
store the adjust-
ment value.
Measurement
PC test mode Test-
equip-
ment
1) Adj item: Devia-
[NXDN High Devia- tion
tion (NXDN Very meter
Narrow)] Oscil-
Deviation meter lo-
LPF: 3kHz scope
HPF: OFF
2) Adj item:
[Frequency:
700MHz Band]
[RX/TA Low]→
[RX/TA High]→
[TX Low]→
[TX High]
[Frequency:
800MHz Band]
[TX Low]→
[TX High]→
[RX/TA Low]→
[RX/TA High]
Press [Transmit]
button.
Press [Apply All]
button to store the
adjustment value.
1) Adj item: Devia-
[QT Deviation (An- tion
alog Wide 5k)] meter
Deviation meter Oscil-
LPF: 3kHz lo-
HPF: OFF scope
2) Adj item:
[Frequency:
700MHz Band]
[RX/TA High]→
[TX High]
[Frequency:
800MHz Band]
[TX High]→
[RX/TA High]
Press [Transmit]
button.
Press [Apply All]
button to store the
adjustment value.
Unit Ter- Unit Parts
minal
Panel ANT Panel [Panel
tuning
mode]
[ ],
[ ]
[PC
test
mode]
[←],
[→]
Panel ANT Panel [Panel
tuning
mode]
[ ],
[ ]
[PC
test
mode]
[←],
[→]
Adjustment
Method
Write fixed value "503" 1311~1363Hz
for each adjustment
point. Transmit at each [PC test
adjustment point and mode]
check that the deviation Press [Apply
is between 1331Hz and All] button to
1363Hz. store the
Deviation meter adjustment
LPF: 3kHz value after all
HPF: OFF adjustment
points have
[Panel tuning mode] been adjusted.
PTT: ON
[PC test mode]
PTT: Press [Transmit]
button
Write the value as fol- 0.75kHz±0.05
lowings. 513 (Reference kHz
value)
(No.RA016<Rev.001>)1-49
Specifica-
tions
/Remarks