Toshiba MMU-AP0091H Owner's Manual Installation And Operation page 87

High Wall Type (MMK-AP
For the Flow Selector unit that have power supply cord, connect a power supply cable to it as mentioned below.
1. Open the air inlet grille upward.
2. Remove the four screws securing the front panel.
3. Slightly open the lower part of the front panel then pull the upper part of the front panel toward you to remove
it from the rear plate.
4. After removing the front panel, remove the wiring cover and the cord clamp.
5. Connect and secure the power supply cable of Flow Selector unit and secure the cord clamp.
6. The control wires are included in terminal block part of the power supply.
Take out the control wires outwards through the slit of the terminal block.
7. Fasten the wiring cover surely with screws.
8. Connect the control wire taken out through the slit on the terminal block and the control wire from the Flow
Selector unit at the relay terminal section.
Floor Standing Cabinet Type (MML-AP
Earth screw
Attached wire
(Control wiring)
Cord clamp
Attached wire
(Power supply)
2H Series)
Terminal
block
Control wire
Control wire from the
Flow Selector unit
Earth screw for Flow Selector unit
R(L), S(N) terminal
block for power supply
Terminal
block
Power supply cable
for Flow Selector unit
Slit of the
terminal block
1H Series)
Indoor P.C. board
Faston connection
84
Earth line
Cord clamp
Screw
Wiring cover
CN081 (Black)
Screw
Screw