Toshiba MMU-AP0091H Owner's Manual Installation And Operation page 60

7
ADDRESS SETUP
• To change all the indoor addresses from an arbitrary wired remote controller;
(When the setup operation with automatic address has finished, this change is available.)
Contents : Using an arbitrary wired remote controller, the indoor unit address can be changed for each same
refrigerant line.
∗ ∗ ∗ ∗ ∗ Change the address in the address check/change mode.
<Procedure> (Operation while air conditioner stops)
1
Push the timer time
Firstly, the line 1, item code
2
UNIT
Using / SWING/FIX
3
SET
Push button.
• The indoor address, which is connected to the refrigerant line of the selected header unit is displayed and the
fan is turned on.
First the current indoor address is displayed on the setup data. (Line address is not displayed.)
4
The indoor address of the setup data moves up/down by the timer time
Change the setup data to a new address.
5
SET
Push button to determine the setup data.
6
UNIT
Every pushing
displayed. Only fan of the selected indoor unit operates.
Repeat the procedure
7
SET
Push button.
(All the displays on LCD go on.)
8
TEST
Push button to finish the procedure.
SET DATA SETTING
TEMP.
TIMER SET
1
TIME
FILTER
RESET TEST SET CL
3
Deletion of line selection
Here, if the unit No. is not called up, the header
unit in this system does not exist.
CL
Push button, and then select a line
according to procedure
TEST
+ buttons simultaneously for 4 seconds or more.
AC
(Address Change) is displayed.
buttons, select the line address.
button, the indoor unit numbers in the same refrigerant line are successively
4 6
to and change all the indoor addresses so that they are not duplicated.
CODE No.
UNIT No.
R.C. No.
ON / OFF
FAN MODE
SWING/FIX VENT
UNIT
2
.
4
2
8
Operation procedure
® ®
1 2 3
57
/ buttons.
CODE No.
SET DATA SETTING
UNIT No.
R.C. No.
TEMP.
ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
FILTER
RESET TEST SET CL UNIT
5, 7
To finish the set
® ® ® ®
4 5 6
6
®
7 8
End