Toshiba MMU-AP0091H Owner's Manual Installation And Operation page 13

How to set up the air direction
SWING/FIX
Push button.
1
Every pushing the button, the air direction changes.
In Heating operation
Set the air outlet flap downward.
If directing it upward, the hot air may not come to the foot.
In Cooling / Dry operation
Set the air outlet flap upward.
If directing it downward, the dew may fall on near the air discharge port or it drips.
How to start swinging
2
SWING/FIX
Push button.
Set direction of the air outlet flap to the
lowest position and then push
again.
• [SWING ] is displayed and the air direction
automatically changes upward/downward.
In case when one remote controller controls
the multiple indoor units, each indoor unit can
be selected and its air direction can be set up.
How to stop swinging
3
SWING/FIX
Push button again during swinging of
the air outlet flap.
• The air outlet flap can be stopped at the
desired position. After then the air direction
can be again set up from the uppermost
position by pushing
* While the air outlet flap is set downward in
cooling/drying operation, it does not stop.
If stopping the air outlet flap which directs
downward during swinging, it stops after
moving to the 3rd position from the top
position.
4
UNIT
• To set up the air direction individually, push
UNIT
button to display each indoor unit No. in
a group control. Then set up the air direction to
a displayed indoor unit.
• If there is no display, all the indoor units can be
operated collectively.
UNIT
• Every pushing
exchanges as shown in the figure.
SWING/FIX
button
SWING/FIX
button.
button, the display
TEMP.
TIMER SET
FILTER
RESET TEST SET CL
1, 2, 3
In FAN operation
Initial setup
Display when stopping the swing
Fan/Heat
operation
No display
Unit No. 1-4
10
Initial setup
Initial setup
ON / OFF
FAN MODE
TIME SWING/FIX VENT
UNIT
4
In all modes
Series of
operation
Cool/Dry
operation
Unit No. 1-1 Unit No. 1-2
Unit No. 1-3