Has The Paper Type Been Set Correctly - Sharp MX-B455W Troubleshooting Manual

General Problems
WHEN PRINTING ON THICK PAPER, THE PRINT
?
RESULT IS DIRTY FROM THE 2ND PAGE ON
Check
Has the paper type been set
correctly?
PART OF THE IMAGE IS CUT OFF
?
Check
Has the correct paper size been set?
Was the original placed in the correct
position?
Does the original size shown on the
touch panel match the actual size of
the original?
PRINTING TAKES PLACE ON THE WRONG SIDE
?
OF THE PAPER
Check
Is the paper loaded with the print side
facing in the correct direction?
!
Solution
■ Set the correct paper type in the tray settings. Make sure that the following did
not occur:
• When using heavy paper, change the paper type in the tray settings to Heavy.
(The image may disappear if rubbed.)
• Paper other than heavy paper is being used, but heavy paper is selected in the
tray settings. (This may cause creases and misfeeds.)
 "Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration]
!
Solution
■ Be sure to specify the paper size.
 "Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration]
■ If you are using the document glass, be sure to place the original in the far left
corner of the document glass.
► Placing the original and adding paper (page 5)
■ Check if the size of the original you placed matches the paper size setting. If not,
set the correct original size.
!
Solution
■ Make sure that the print side of paper is facing in the correct direction.
• Trays 1 to 4:
Place the paper with the print side face up.*
• Bypass Tray:
Place the paper with the print side face down.*
* When the paper type is "Pre-Printed" or "Letter Head", load the paper in the
opposite way.
(Except when [Disabling of Duplex] is enabled in the setting mode (administrator).
For information about the setting mode, consult your administrator.)
15