Pfaff 1571 Instruction Manual page 66

Input
The fifth seam section should have
- a double end backtack
- a 5 mm stitch length (for roller presser and feed wheel)
- backtack speed of 700 spm
- a stitch count (1 stitch)
- and the thread trimming function at the end of the seam section.
By pressing the end backtack key, switch on the corresponding function.
The display changes for the input of the number of stitches for the end backtack
C
D
66
5
5 5.0
By pressing the corresponding +/- key set the stitch length for the roller presser
at "5.0 ".
By pressing the corresponding +/- key set the stitch length for the feed wheel at "5.0".
5 C
5 1
By pressing the corresponding +/- key set the number of reverse stitches at "1".
By pressing the corresponding +/- key set the number of forward stitches at "1".
By pressing the corresponding +/- key set the backtack speed at "700".
By pressing the stitch count key, switch on the corresponding function.
The display changes for the input of the number of stitches.
If the "stitch count" function was already switched on, the menu appears for entering
the stitch number after pressing the scrolling key.
5
5
5.0
D
1 700
1