Icom IP501H Instruction Manual page 67

6
FOR YOUR REFERENCE
■ Troubleshooting (continued)
PROBLEM POSSIBLE CAUSE
"Paring list is full" is Number of paired devices exceeds the
displayed in the Pairing maximum number.
screen.
The call was suddenly Too far from the Bluetooth device.
cut off /Noise is heard (When using a Bluetooth headset)
Electromagnetic interference from other
electronic devices.
No audio output from IP501H is in the Bluetooth signal detecting
IP501H after sequence. (Approximately 20 seconds)
the Bluetooth connection
with BC-218 is
disconnected.
No sound comes from The volume level is set too low.
the earphone that is
connected to the VS-3.
Loose earphone plug connection.
SOLUTION
Delete a Bluetooth device from the
pairing list.
Get closer to the Bluetooth device.
L The communication range of
Bluetooth is approximately 10
meters (33 feet).
Use the transceiver away from the
other devices, or stop using those
devices.
Push the Bluetooth button on the BC-218
to disconnect the Bluetooth device,
then turn OFF the BC-218 power.
Increase the VS-3's volume level.
Increase the IP501H's volume level.
( When "Bluetooth Synchronous Volume"
is set to valid)
Firmly insert the plug.
6-3
REFERENCE
p. 5-21
–
–
–
p. 5-11
pp. 1-3, 4-6
p. 1-4