Installing The Mba-7/Mbf-1 On A Flat Surface - Icom IP501H Instruction Manual

5
OPTIONAL PRODUCTS

■ Installing the MBA-7/MBF-1 on a flat surface

1. Clean the surface where the MBF-1 is attached to.
LTo install the MBF-1, approximately 90 mm
2. Attach the MBA-7 to the MBF-1.
Move the holder left or right to
e
the best viewing position,
then tighten the lock knob.
MBA-7
of flat surface is necessary.
2
Slot
Turn the Holder so the slot can be placed over the locking head.
w
Turn the holder back forward, and slide the slot's guide under the MBF-1's locking head.
Locking head Locking head
Lock knob
Holder
MBF-1
q Loosen the lock knob
5-25