Getting Started - Cradlepoint AER2100 Quick Start Manual

Quick Start Guide / AER2100 Series

GETTING STARTED

Insert an Activated SIM
A wireless broadband data plan must be added to your Cradlepoint AER2100.
Wireless broadband data plans are available from wireless carriers such as
Verizon, AT&T, Sprint, EE, and Vodafone. The SIM must be provisioned with
the carrier. Contact your carrier for details about selecting a data plan and
about the process for provisioning your SIM.
Once you have an activated SIM, insert it into the integrated modem. Insert
the SIM card into the slot marked SIM 1 (use the other slot, SIM 2, for a
secondary/backup SIM). Be sure to insert the card with the notch-end first
and the gold contacts facing down—it will click into place.
Attach the Internal Modem
Follow these steps to attach the internal modem:
1. Remove the left side panel cover from the router. Use a Phillips
screwdriver to remove the screws, and use the Multipurpose Retaining
Tool (included in the router package) to remove the cover.
2. Slide the modem into the side of the router
(left slot first). The protruding section of the
modem fits into the groove.
3. Reattach the panel cover and screw it back on.
(When necessary, remove the cover and modem
using the Multipurpose Retaining Tool.)
4
Attach the WiFi & Modem Antennas
Attach the three included WiFi antennas and two included modem antennas to
the connectors. Antennas are jointed, which enables you to position them for
optimal signal. To attach, hold the antenna straight and twist the base of the
antenna to connect, folding the joint if needed.
When connecting the provided antennas, review the connection points.
+ WiFi antennas have flat circular bases (RSMA).
+ Modem antennas have protruding pins (SMA).
Care should be taken to ensure that the router antennas are not near metal or
other RF reflective surfaces.
Connect the Power Source
Plug the provided power supply (12V DC wall adapter) into an electrical outlet.
Then connect the power supply to the router. Ensure power is switched on.
When you set the power switch
to the 'On' position, watch for the
power LED to illuminate.
If you would like to secure the power
supply cord, attach the Multipurpose
Retaining Tool as shown. Secure with
included screws.
©Cradlepoint. All Rights Reserved. | +1.855.813.3385 | cradlepoint.com