BMW R 1200 R 2007 Rider's Manual page 69

with OE Automatic Stability
Control (ASC):
Switch on ignition.
Pre-ride check is performed.
( 67)
ABS self-diagnosis is
performed. ( 68)
ASC self-diagnosis is per-
formed. ( 69)
Press starter button 1.
At extremely low tempera-
tures it may be necessary
to operate the throttle twist grip
during starting. At ambient tem-
peratures below 32 °F (0 °C),
actuate the clutch after switching
on the ignition.
The start attempt is auto-
matically interrupted if bat-
tery voltage is too low. Recharge
the battery before you start the
engine, or use jump leads and a
donor battery to start.
Engine starts.
Consult the troubleshooting
chart if the engine refuses to
start. ( 126)
Pre-ride check
After the ignition is switched on,
the instrument cluster conducts
a test of the pointer instruments
and the warning and indicator
lights, i.e. the Pre-Ride-Check.
The test is aborted if you start
the engine before it completes.
Phase 1
The pointer of the tachometer
and speedometer are run up to
the end stop.
At the same time, the following
warning and indicator lights are
switched on consecutively:
Indicator light for high-beam
headlight and telltale light for
left turn indicator
General warning light in yellow
Fuel-reserve warning light and
idling indicator light
Engine oil-pressure warning
light and battery charge-current
warning light
Indicator light for right turn indi-
cator
with OE BMW Motorrad Integral
ABS:
The ABS warning light is
switched on together with the
indicator light for the left turn
indicator.
5
67
z