BMW R 1200 R 2007 Rider's Manual page 109

ommends BMW Motorrad rear
wheel stand.
Installing rear-wheel stand
( 108)
with OE Center stand:
Make sure ground is level and
firm and place motorcycle on
its center stand.
Loosen adjusting screws 1.
Push two mounts 2 far enough
apart that front forks fit be-
tween them.
Use locating pins 3 to set front
wheel stand to desired height.
Center front wheel stand rela-
tive to front wheel and push it
against front axle.
Align two mounts 2 so that
front forks rest securely on
them.
Tighten adjusting screws 1.
If the motorcycle is resting
on the center stand: The
motorcycle is raised too far at the
front, the center stand lifts off the
ground and the motorcycle can
tip over to the side.
When raising the motorcycle,
make sure that the center stand
remains on the ground.
Apply uniform pressure to push
front wheel stand down and
raise motorcycle.
8
107
z