Parameters (Profibus Pa) - Siemens sitrans LR 400 Instruction Manual

Parameters (PROFIBUS PA)

Note: For parameter descriptions, please refer to the associated HART parameters on
pages 27 to 56.
Parameter, menu
identification
1: Auto-Setup
1.1 Language local
1.2 Length unit
1.3 Nozzle height
1.4 Tank height
1.5 Level URV
1.6 Level LRV
1.7 Level damping
1.8 Application type
1.9 Bus address
2: Display
2. 1 : Multi-display
2.2: Level
2.3: Volume
2.4: Mass
3: Diagnostics
3.1: Status
3. 1 .1: Wear
7ML19985JC02
Parameters (PROFIBUS PA)
Description
Selects the language to
be used on the LCD
Specifies measurement
units used for dimension
values
Specifies length of noz-
zle from top of device
flange to top of vessel
Specifies height of ves-
sel from nozzle bottom to
vessel bottom
Sets the full scale of level 20 m
Sets the distance from
the bottom of the vessel
to the empty level
Sets the damping of the
level value in seconds
Sets the use of the vessel Liquid
Current bus address
Display of two measured
values
Level of material
Volume of material
For qualified personnel only
SITRANS LR 400 (Solids) – INSTRUCTION MANUAL
Factory Setting
Setting Possibilities
English English
Deustch
m cm
m
mm
ft
in
0 m numerical value
20 m numerical value
numerical value
0 m numerical value
1 s numerical value
Liquid (store)
(process) Liquid (process)
Silo1 (solids)
Silo2 (solids)
User tank1
User tank2
126 0 to 126
Level/Signal- non-editable
to-noise ratio
in dB
m non-editable
non-editable
3
m
Page 59