Lubrication Locations - Ariens 932031 - ST524 Owner's/Operator's Manual

1
Level
1. Auger Gearcase - Cast Iron
2. Oil Fill and Drain level plug
3. Ariens Special L-2 Gear Lube
2. Add lubricant, if required, allow oil to drain to level of
plug and replace plug (Figure 9).
3. Use only Ariens special gear lube L-2 (Part Number
00008000).
L L
UBRICATION OCATIONS
WARNING
HOT SURFACES can result in death or
OL0100
serious injury. DO NOT touch parts
which are hot from operation.
ALWAYS allow parts to cool.
IMPORTANT: Wipe each fitting clean before and after
lubrication.
IMPORTANT: DO NOT allow grease or oil to get on
friction wheel, drive disc or belts.
Apply Hi-Temp Grease or equivalent to the
lube fittings. Order P/N: 00036800 - Three Pack of 3 oz.
cartridges or 00036700 - 10 pack of 14 oz. cartridges.
Apply oil at lubrication points.
Unit should be lubricated at beginning of season or every
25 operating hours (Figure 10). See Maintenance
Schedule.
NOTE: To grease auger shaft, remove shear bolt nuts,
and shear bolts. Turn auger on shaft while applying
grease at zerk fittings. Replace shear bolt per instructions
in Shear Bolt Replacement.
Rev. 8/97
2
Figure 9
Ariens
3
2
OS0620
1. Discharge Chute
Base
2. Auger and Shaft
3. Wheel Drive
Spring Package
932 Series Sno-Thro
® ®
1
2
2 2
5
4
6
3
4. Hex Shaft
5. Bearing Flange
Pin
6. Bushing
Figure 10
OS1370
17