Audio/Video Dubbing - RCA Pro942 User Manual

Audio/Video Dubbing

A/V (audio/video) DUB on the remote lets you record new audio and video from
another VCR or camcorder to a previously recorded tape in the camcorder. You
will need an optional VAA009 audio/video input cable shown on page 61.
Notes: The source for audio and video when dubbing is the signal coming through the
audio and video plugs of the audio/video input cable.
If you connect only the video plug of the audio/video input cable to the VCR, you will
have no sound on the dubbed portion.
If you connect only the audio plug of the audio/video input cable to the VCR, the
camcorder will not dub.
Back of
Mono
VCR
1 White Audio Plug
AUDIO
OUT
VIDEO
OUT
2 Yellow Video Plug
Back of Optional Y-Adapter
Stereo (such as AH25)
VCR
L
AUDIO
OUT
R
VIDEO
OUT
2
Installation
1 Attach the input cable's white plug to
the AUDIO OUT jack of the VCR.
Note: If your VCR has left and right
stereo AUDIO OUT jacks, attach the plug
to the one labeled MONO. If one is not
MONO, you may need a Y-adapter to
record both channels.
2 Attach the input cable's yellow plug to
the VIDEO OUT jack on the VCR.
42
Optional VAA009
Audio/Video
Input Cable
3
or
Audio/Video In/Out
Connector (located
behind small cover)
1 White Audio Plug
Yellow Video Plug
Optional VAA009
Audio/Video
Input Cable
3 Attach the plug on the other end of the
input cable to the audio/video in/out
connector located behind the small
cover on the side of the camcorder.
(Match the tabs on the plug with the
notches on the camcorder connector.
Do not force the plug.)
3