Setup - Chicago Electric 68829 Owner's Manual & Safety Instructions

Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical
outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following
pages, refer to Parts List and Diagram on page 14.
Mounting
Place your Table Saw on a flat, level surface capable of supporting
weight of Table Saw and material being cut.
Assembly - Guard Installation
WARNING! check guards for proper operation with saw disconnected from power
before each use. Do not disable any guard. Do not operate saw if any movable
guard does not move freely and close instantly. Make sure any movable guard
does not touch the blade in all angles, depths of cut, and positions.
1. Remove the Screw (6) at the
end of the Guard (4).
2. Align the hole in the center of the
Eye Guard (5) with the hole in the Guard (4).
3. The hole in the Eye Guard (5) is countersunk
to accommodate the Screw. Secure using the
Screw (6), being careful not to overtighten.
4. Swing the Guard Bracket (1) up
and remove the top Screw (3).
5. Slide the Guard (4) over the Bracket,
aligning the holes in the Guard
with the hole in the Bracket.
NOTE: Make sure that the Eye Guard is on
the top side of the guard and that the rounded
underside of the Guard rests over the blade.
6. Install the Screw (3) to secure
the Guard in place.
Item 68829 For technical questions, please call 1-800-444-3353.
Eye Guard
Screw
Figure A: Guard Installation
Guard Screw
Guard
Bracket
Page 9