Setup; Before Use - Chicago Electric 61971 Owner's Manual & Safety Instructions

Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Turn the Power Switch of the tool
off and unplug the tool from its electrical outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the
following pages, refer to Parts List and Diagram on page 17.
Assembly
1. Insert the ends of the Table Extensions into
the holes in the sides of the Base. Tighten the
Wing Screws to hold the Extensions in place.
The upper edge of the Extensions will be level
with the surface of the saw. This provides a
wider base for the work material to rest on.
Mounting the Saw
Use the four bolt holes provided in the Base to mount the Miter Saw to a
stable support before use. Mounting hardware not included.
Functions
Blade Guard
Spindle
Lock
Blade
Laser
Switch
Table
Page 8
Head
Lockdown
Pin
For technical questions, please call 1-888-866-5797.
2. Thread the Miter Knob into the end of the Table
below the Miter Lock until securely in place.
3. Slip the Dust Bag over the Dust Outlet
at the rear of the saw.
Dust Outlet
Dust Bag
Bevel
Lock
Lever
Item 61971